Have you ever had a problem changing your engine oil? If you have a Ford Escape or a Ford Focus, then you don’t have to worry, because today I will tell you in detail how to properly change the Motor Oil for Ford Escape and Oil for Ford Focus Diesel. In fact, it’s not as hard as it seems! In addition, I will definitely give you the most useful tips on how to make this process even faster. So, if this interests you, then keep reading this article.
How to Change the Oil in the Ford Escape Engine
One of the most important and mandatory procedures when servicing a Ford Escape is to change the oil in the engine. If you don’t change the oil in your Ford Escape, the performance of the engine oil will begin to decline as a result of the engine oil thickening and the ingress of foreign particles of dust, dirt, or fine chips into its substance.
The oil change period for Ford Escape is every 5-10 thousand km (kilometers) or 1 year. This should consider not only the driving characteristics and the terms stated by the manufacturer.
The process of replacement of Motor Oil for Ford Escape takes place in several stages:
- turn off the engine
- unscrew the drain plug and drain the old oil to the maximum
- change the oil filter
- flush the engine of Ford Escape with the addition of special cleansing additive
- pour in new oil
After completing the oil change in a Ford Escape procedure, you need to start your Ford Escape and let it idle for a while (3-5 minutes). Then you should check the engine oil level again, and top it up if necessary.
The stage of flushing the engine of the Ford Escape today causes a dual opinion. Such a process prevents problems associated with the clogging of oil ducts, the accumulation of deposits, and clogging of certain parts of the truck. But when you carry out the drain of used oil in the system can remain a significant amount of it.
Ford Escape owners should pay special attention to the problem of choosing a gas station that provides high-quality fuel. The use of gasoline blends with low properties has a negative impact on oil composition. The result of such a process is the darkening and contamination of the engine oil due to the ingress of unburned fuel substances, significantly reducing the engine life of the Ford Escape. To avoid the risks associated with engine repair and deterioration of its performance, you can use proven gas stations of famous brands.
Changing the Oil in the Ford Focus
For the work you will need:
- 13 mm (millimeters) wrench
- oil filter remover
- a new oil filter
- a container for draining the oil, convenient and safe for change, such as an overpass or an inspection pit
Change the Oil for Ford Focus Diesel on the warmed-up engine, because it is more thorough and faster drained. To change the oil in the engine you need to put a container under the drain hole of the pan and unscrew the plug with a wrench 13. When removing the plug, you need to be careful not to burn your hands.
Changing the oil filter will require a puller if the filter cannot be unscrewed by hand. When unscrewing the filter, you must remember that oil will also leak from it, so you must move the used oil container under the filter. The sealing rubber on the new filter should be lubricated with oil before installation. The oil filter is screwed in by hand and should be tightened 3/4 turn after the rubber band touches the seat.
After checking that the drain bolt and oil filter are tight, you can pour oil into the engine. Note that only a small amount of oil for Ford Focus should be poured in, and then the filler cap should be tightened and the engine started for a few minutes.
You will then notice that the oil pressure warning light goes out 2-3 seconds after starting. After shutting off the engine and waiting a couple of minutes while the oil drains into the sump, you can check the level with the dipstick. The edge of the oil should be between the upper and lower mark, closer to the upper mark.
Leave a Reply